Product Name: HC-SR501 Human Infrared Pyroelectr Sensor PIR + 5V 1 Channel Relay Module

You can use HC-SR501 Human Infrared Pyroelectric Sensor Module to control the relay module. The output port of relay module can be connected to such loads as light. When there is human going into the induction area of HC-SR501, the module will output high level, changing the output status of the relay, and controls other equipments. Material Download here!
HC-SR501 Human Infrared Pyroelectric
Sensor Module:
Electrical parameters:
Product Type: HC--SR501 Body Sensor Module Operating voltage range: DC 4.5 -20V
Quiescent Current: <50uA Level output: High 3.3 V /Low 0V Trigger: L can not be repeated trigger/H can be repeated trigger(Default repeated trigger) Delay time: 5-200S(adjustable) the range is (0.xx second to tens of second) Block time: 2.5S(default)Can be made a range(0.xx to tens of seconds Board Dimensions: 32mm*24mm Angle Sensor: <100 cone angle Operation Temp: -15-+70 degrees Lens size sensor: Diameter:23mm(Default)

Features: 1, the
automatic sensor: to enter the sensor output range is high, people leave the sensor range of the automatic delay off high, output low. 2, the photosensitive control (optional, factory is not set) may set the photosensitive control during the day or light intensity without induction. 3, the temperature compensation (optional, factory
is not set): In the summer when the ambient temperature rises to 30 ~ 32?, slightly shorter detection range, temperature compensation can be used as a performance compensation. 4, two
trigger mode: (can be selected by jumpers) a, can
not repeat the trigger: the sensor output high, the delay time is over, the output will automatically become low from high; b, repeatable
trigger: the sensor output high after the delay period, if the human body in its sensing range activities, its output will remain high until after the delay will be left high to low (sensor module review Measured activities of each body will be automatically extended after a delay time, and the final event of the delay time Starting point of time). 5, with induction blocking time (the default setting: 2.5S
block time): sensor module, after each sensor output (high change Into a low level), you can set up a blockade followed by time period, in this time period the sensor does not accept any sensor signal. This feature can have a "sensor output time" and "blocking time" the interval between the work produced can be applied to detect the interval Products; also inhibit this function during load switching for a variety of interference. (This time can be set at zero seconds - Tens of seconds). 6, the
working voltage range: the default voltage DC 4.5V -20V.
7,
micro-power consumption: static current "50 microamps, especially for battery-powered automatic control products. 8, the
output high level signals: types of circuits can be easily and docking.
Instructions:
1. Sensing module for about a minute after power initialization time, during the interval to the output module 0-3 times a minute in standby mode.
2. Should avoid direct lighting such as interference sources close the surface of the lens module so as to