What Is A Stud Finder?
As the name suggests a stud finder detects studs behind the surface of a wall.
Detection is achieved using two different methods:
1. Magnetic
Uses powerful magnets to pinpoint the location of screws or nails in a stud. Therefore it doesn't detect the stud itself but rather the hardware that attaches the wall material to the stud.
2. Electronic
Electronic stud finders rely on sensors that detect changes in the dielectric constant (the relative permittivity) of the wall. This changes when the sensor is over a stud. The lower reading indicates the presence of a stud in the wall and the signal will let you know by the colored lights. eOUTIL ST100 stud finder is an electronic style.
How To Use eOUTIL ST100 Stud Finder?
Step 1: Take off the battery cover and load your own 9V 6F22 battery, then ready to go
Step 2: Place the device flat on the wall. Then press and hold the button while keeping the unit still until calibration is complete (1 - 2 seconds). When calibration is complete, the unit will sound a short beep
Step 3: While holding on the button, move it along the desired surface to scan.
Step 4: When the stud finder detects a side of object, it will beep continually and flashing the lamp, mark this place with a pen, keep moving to find another side, mark again.
Stud-Finding Tips: Dont touch the wall with either hand while youre using a stud finderthis can alter its readings.
How to load your own 9V 6F22 battery?
As the name suggests a stud finder detects studs behind the surface of a wall.
Detection is achieved using two different methods:
1. Magnetic
Uses powerful magnets to pinpoint the location of screws or nails in a stud. Therefore it doesn't detect the stud itself but rather the hardware that attaches the wall material to the stud.
2. Electronic
Electronic stud finders rely on sensors that detect changes in the dielectric constant (the relative permittivity) of the wall. This changes when the sensor is over a stud. The lower reading indicates the presence of a stud in the wall and the signal will let you know by the colored lights. eOUTIL ST100 stud finder is an electronic style.
How To Use eOUTIL ST100 Stud Finder?
Step 1: Take off the battery cover and load your own 9V 6F22 battery, then ready to go
Step 2: Place the device flat on the wall. Then press and hold the button while keeping the unit still until calibration is complete (1 - 2 seconds). When calibration is complete, the unit will sound a short beep
Step 3: While holding on the button, move it along the desired surface to scan.
Step 4: When the stud finder detects a side of object, it will beep continually and flashing the lamp, mark this place with a pen, keep moving to find another side, mark again.
Stud-Finding Tips: Dont touch the wall with either hand while youre using a stud finderthis can alter its readings.
How to load your own 9V 6F22 battery?
