Austere III Series Speaker Cable 50 ft spool, oxygen-free copper Which gauge do you need? Lower gauge means thicker wire, more copper, and less resistance over distance.
As a general guide: 16 AWG suits short runs to bookshelf or surround speakers, 14 AWG covers most typical living-room runs, and 12 AWG is the choice for long runs across a room, in-wall installs, low-impedance speakers, or a high-power amplifier. When in doubt, go thicker a heavier gauge never hurts performance. Bare wire, 50 feet on one spool. This is unterminated speaker wire, not a pre-made cable with plugs. Cut it to the lengths your install needs, strip the ends, and connect to spring clips or binding posts. For a cleaner connection at the amplifier or speaker, add Austere Banana Adapters, sold separately. Fifty feet covers one long run or several shorter ones measure your route along baseboards and around corners, not straight across the room, and add slack at both ends. Fine-stranded oxygen-free copper. The conductor is 100% pure oxygen-free copper drawn into fine strands and bundled, which keeps resistance low and resists the corrosion that degrades a connection over years. Highs, mids, and lows arrive together, so nothing in the cable colors what your speakers reproduce.
SoftTouch high-flex jacket. The jacket is built to bend rather than fight you it routes along baseboards, turns corners, and tucks under carpet edges without kinking or holding a coil memory. Precision pull marker. A marked point on the cable limits stress during a pull, so you can feed it through a wall, conduit, or a tight cabinet without over-tensioning the conductor. What it connects. AV receivers, stereo amplifiers, and integrated amps to floorstanding, bookshelf, center-channel, surround, in-wall, in-ceiling, and outdoor speakers. Works with any amplifier using spring clips or binding posts. Limited Lifetime Guarantee. Austere stands behind this cable for its lifetime.