Meet Your Seller

Wireless HDMI Transmitter and Receiver, RX Only

This is an RX-only unit. It supports a maximum configuration of 1 transmitter (TX) to 4 receivers (RX). Additional RX units can be added as needed. Please note: As the number of RX units increases, the wireless transmission distance decreases. Theoretical line-of-sight distances are as follows: 1 TX to 1 RX is 200m (656ft); 1 TX to 2 RX is 60m (196ft); 1 TX to 3 RX is 30m (98ft); and 1 TX to 4 RX is 20m (65ft). IMPORTANT: Pairing Instructions for TX and RX Step 1: Initial State - Unpaired. Please note: Each transmitter supports a maximum of four receivers. Every new receiver must be paired with the transmitter before its initial use. Step 2: Power On. First, power on both the TX and RX units using a 12V/1A power adapter, then wait for 5 seconds. Step 3: Connect for Pairing. Use an HDMI cable to connect the TX-IN port to the RX-OUT port as described. Wait approximately 5-10 seconds for the auto-pairing process to complete. Step 4: Finalize Pairing. Re-plug the power adapter. Once the IP address and Wi-Fi signal are displayed, the pairing is successful. Please note: Repeat Steps 2 and 3 to pair RX#2, RX#3, and RX#4. (RX#1 through RX#4 should display the same IP address.)

Specs

Reviews

Additional Information
First Listed on Newegg	August 02, 2026

Please contact the Seller directly for warranty information. Warranty information may also be found on the Manufacturer's website.
CONTACT