ESP32-S3 2.8inch Round Display Development Board,480×480 Resolution 2.8I2C LCD RGB Display Supports GPIO, UART and I2C Interfaces,Supports WiFi & Bluetooth

ESP32-S3 2.8 inch Round Display Development Board, 480×480, 32-Bit LX7 Dual-Core Processor, Supports WiFi & Bluetooth,, ESP32 With Display. Features This product is a microcontroller development board with 2.4GH z WiFi and Bluetooth BLE 5 support, integrates high-capacity Flash and PSRAM. Onboard 2.8 inch LCD screen can smoothly run GUI programs such as LVGL. Combined with various peripheral interfaces, suitable for the quick development of the HMI and other ESP32-S3 applications. Equipped with high-performance Xtensa 32-bit LX7 dual-core processor, up to 240MHz main frequency Supports 2.4GH z Wi-Fi ( 802.81 b/g/n) and Bluetooth 5 (LE), with onboard antenna Built-in 512KB SRAM and 384KB ROM, with onboard 16MB Flash and 8MB PSRAM Onboard 2.8 inch LCD display, 480×480 resolution Supports touch control via I2C interface, with interrupt support (for touch version only) Adapting UART, I2C and some IO interfaces, integrates full-speed USB port Onboard QMI8658 6-axis sensor, RTC sensor, TF card slot and battery recharge management module, etc.

Supports accurate control such as flexible clock and multiple power modes to realize low power consumption in different scenarios Package Content ESP32-S3-LCD- 2.8C x1 SH 1.0 12PIN cable ~100mm ×1 SH 1.0 4PIN cable ~100mm (2pcs) ×1 FAQ 1. After the module downloads the demo and re-downloads it, why sometimes it can't connect to the serial port or the flashing fails? Click the Reset button for more than 1 second, wait for the PC to re-recognize the device and then download again Long press the BOOT button, press RESET at the same time, then release RESET, then release the BOOT button, at this time the module can enter the download mode, which can solve most of the problems that can not be downloaded.