ALadrs Resin Flex Building Plate for M5S 9.05 x 5.32 inch Spring Steel Flexible Plate and Magnetic Base Platform for Anycubic Photon M5S Pro Resin 3D Printe 230 x 135 mm 1pcs

Applicable model: 230 x 135 mm is made for Anycubic Photon M5S and M5S Pro This resin magnetic flexible steel plate flex bed is also can used for the plate 's size which is longth between 230-240 mm the width between 135-145mmHigh durability: Flexible steel plate with high chromium content easy to bend and clean. Much easier to remove prints and avoid damages during the process especially for small prints. Good corrossion resistance and prevent rust. Brushed surface provides better adhesion ensure a perfect print. At the same time after installing the magnetic printing platform you will need to re-leveling the 3D printer for excellent printing results.
Easy to operate: Traditional DLP light-curing printer platforms must use tools to disassemble while this resin flexible board can be disassembled by bending. Easier removal of printed models from the resin build surface. Makes it easier to remove prints and avoid damage in the process especially for small prints.
Clever design: The magnetic printing platform is equipped with a handle that makes it easy to install and remove the magnetic printing platform.
Installation method: Thoroughly clean and dry the printing platform plate attach the magnet to the printing platform plate and let it sit for a while to fully seat it install the spring steel plate on the magnetic base again and finally reset and level the printer. Set to start printing. It is recommended to print (A4) 3.8 mm thick sps to facilitate the normal zeroing of the Z axis.