Built for How Business Buys.
Built for How Business Buys.
The Alphacool HardTube 13/10mm 60cm - 4 Pack - Plexi is a pack of 4 clear acrylic (PMMA) hard tubes for water cooling, 13 mm outer and 10 mm inner diameter, each 60 cm long. Attention: it is not compatible with Monsoon fittings.
Alphacool's announcement reads: the HardTube project becomes a reality, and Alphacool takes a completely new way and clearly sets an example. The method most commonly used previously for water cooling systems is normal PVC hoses, and Alphacool now offers another approach to designing a loop. It says the HardTube again brings more tidiness into the system, which makes a much more structured impression.
Alphacool's data sheet calls the tubes easy to bend. With the appropriate bending tool you can adapt the plexi tube to the system without needing to use additional angles. Ours are in the silicone bending inserts section. To install the tubes, they must be sawn to the correct length.
A run takes two fittings, one at each end, from our 13mm OD hard tube fittings. Alphacool says the brand new tubes and its HT connectors make installation very simple, and that they connect completely sealed together. Note: due to the made-to-fit pipes, the connections must be plugged on straight with a little effort.
The following options are available from Alphacool: HardTube 13/10 mm clear acrylic and HardTube 16/13 mm clear acrylic, each in 20 cm, 40 cm, 60 cm and 80 cm. Both are also available in a pack of 4. Its scope of delivery for this one is a single item, the 4pcs set.