Watercool MO-RA IV 600 Front Logo aRGB (26641)

An illuminated aRGB logo for the front of the MO-RA IV 600 radiator, held in place by magnets. The Watercool MO-RA IV 600 Front Logo aRGB (26641) runs on +5 V through a 3-pin connector, and a MO-RA IV Active or Passive Control is required to use it.

Properties

• For: MO-RA IV 600
• Operating voltage: +5 V
• Connector: 3-pin (5VDG, 5V)
• Needs: MO-RA IV Active or Passive Control

A lit logo on the front

The illuminated logo makes the MO-RA IV look even more stylish. The high-quality aRGB board is pushed in behind the logo, fixed with magnets and connected to the active or passive control. Thanks to this modular design the installation stays easy.

The board is supported by all common mainboard manufacturers, which means the MO-RA logo can be easily integrated into any lighting concept you already run.

Mounting

Insert the LED board in the middle between the pipe bends, and only rotate it by 90° once it has reached its final position; the magnets then hold it. The required tool is a Torx TX20, and the illustration in the instructions shows how the cable is routed.

What it needs

Watercool's technical data name the MO-RA IV 600 as the compatible radiator. The MO-RA IV LOGO aRGB works only with a MO-RA IV Active or Passive Control, and the scope of delivery includes the cable that connects it. For the area under the same radiator there is the MO-RA IV 600 Ambient Light aRGB (26640).

In the box

• 1x MO-RA IV Front Logo aRGB
• 1x connection cable for passive/active control