The Seco-Larm Enforcer Gigabit PoE Extender, 1-Input to 4-Outputs, will extend power over Ethernet (PoE) signals by an additional 328 feet (100m) for up to 4 PoE devices. This Gigabit PoE extender can connect to PoE cameras, IP access control, IP speakers/intercoms, IP telephony, or other PoE devices using Cat5e or Cat6 UTP cable. You can also use an additional two extenders to increase the total range up to 984 feet (300m). This plug-and-play solution saves you money and hassle by eliminating the need to purchase additional hubs, switches, etc.
and because it supports gigabit transmission speeds, your PoE devices will function and perform better than ever before. Designed for quick and easy setup, this PoE Extender does not require external power or any configuration due to its passive operation. It features auto-sensing technology to self-detect PoE or non-PoE devices. It features a PoE power input of up to 60W and output up to 55W with PoE standards IEEE 802.3 af, IEEE 802.3 at, IEEE 802.3 bt 4 pairs (60W).
Installation Details
: Determine the proper location for mounting the extender between the PoE power source and the PoE device, ensuring that neither cable exceeds 328ft (100m) in length. Mount the extender using 4 screws (not included) and the mounting tabs. Ensure that power is off to the PoE power source and all PoE devices. Connect the cables from the PoE power source to the PoE In port of the extender. Connect the cables from the PoE cameras to the PoE Out port of the extender. Turn on the PoE power source and wait up to one minute for the devices to start and establish connections. Test to ensure that all devices are working properly.
PoE Power Input: Up to 60W.
PoE Power Output: Up to 55W.
Data Link: Both pins 1/2, 3/6 and 4/5, 7/8.
Power Link: Pin 1/2(+), 3/6(aa,! aEURoe) up to 12W for 4 PSE, 25W for 2 PSE.
Dimensions: 4-11/16 x 1-1/8 x 3-3/8 inches (119 x 28 x 85 mm).
Ethernet Speed: 10/100/1000 Mbps half/full duplex.
Manufacturer Part #: NR-P401E-TQ.