Integrated PCIe, MAC+PHY minimizes board space and power usage

Compliant with PCI Express Gen4, Gen3 or Gen2

Supports line rate up to 16.0GT/s,8.0GT/s and 5.0GT/s per lane

Message-Signaled interrupts and legacy INTx PCIe interrupts improves CPU utilization and network performance

Integrated Marvell Alaska PHY featuring NBASE-T technology

6-speed support of 10G/5G/2.5G/1G/100M/10M

Energy Efficient Ethernet (EEE) support

Advanced cable diagnostics

Audio Video Bridging (AVB) and PTP/1588 v2 support

LSO, RSS, DCA and header checksum

Wake-on-LAN power management

Jumbo Frames up to 16Kbytes

IPv4/IPv6, IPv6/TCP, and IPv6/UDP checksum offload

Address Resolution Protocol (ARP)

Transmission Control Protocol (TCP) keepalives support link checking between devices

Support Operating Systems: Windows10(32-bit /64-bit), Windows11(32-bit /64-bit), Linux 3.10 and higher


Package content

1 x PCIe 4.0 X4 AQC113 10GbE mGig Ethernet Card

1 x Users Manual

1 x CD

1 x Low profile bracket

System Requirements

Linux Kernels3.10 and above

Windows10(32-bit /64-bit), Windows11(32-bit /64-bit)

Available PCI Express x4/x8/x16 slot

Cabling Requirements:

Transmission bandwidth Twisted pair type Transmission distance

10Gbps Cat 6a or better 100 meters

5G/2.5G/1000M/100M/10Mbps Cat5e or better 100 meters

LED Indicators

Link speeds LED Orange LED RED

10Gbps ACT blinking No bright

5G/2.5G/1000M/100M/10Mbps ACT blinking statics

Hardware installation

1.Turn off the computer and unplug the power cord

2.Remove the computer cover and the adapter slot cover from the slot that matches your adapter

3.Insert the adapter edge connector into the slot and secure the bracket to the chassis

4.Replace the computer cover, then plug in the power cord

5.Power on the computer




Install Drivers

Windows Operating Systems

You must have administrative rights to the operating system to install the drivers.

1.insert the CD driver bound with PCI Express AQC113 10GbE mGig Ethernet card driver into your CD-ROM drive:

2.if the Found New Hardware Wizard screen is displayed, click Cancel

3.Open the location of the driver file and select the driver file according to the system type.

For Windows 32bit

Type AQC113C\AQC113\DRIVER\v3.1.3\Marvell_FastLinQ_Edge_Win_3.1.3\Installer\Marvell_FastLinQ_Edge_x32_ver3.1.3.0

For Windows 64bit

4.Type AQC113C\AQC113\DRIVER\v3.1.3\Marvell_FastLinQ_Edge_Win_3.1.3\Installer\Marvell_FastLinQ_Edge_x64_ver3.1.3.0

5.Double click it

6.Follow the instructions in the install wizard to finish it

Installing Linux Drivers from Source Code

1.Download and expand the base driver tar file.

2.Compile the driver module

3.Install the module using the modprobe command

4.Assign an IP address using the ifconfig command

Support

More information and settings, please refer to the Adapter User Guides or you can contact us.