Bridge PCI Express to USB 3.1
Upload firmware through BIOS or external SPI ROM
External 20MHz differential crystal
Overclock capability on PCI Express bus under asynchronous mode
integrate Spread Spectrum controller for PCI Express and USB3.1 interface
Integrate two regulators for normal core power supply and suspend core power supply
Support driver on Windows 7, Windows 8, and Windows 8.1
Support various Linux Kernels
PCI Express Feature
Support PCI Express Gen2x2 or Gen3x1
Up to 10Gbps bandwidth performance with low latency
Support PCI Express Link power management
Compliant with PCI Express Base 3.0 Specification
Compliant with PCI Express card Electromechanical 2.0 specification
Compliant with PCI Express Mini Card Electromechanical 1.2 specification
Compliant with Express Card Standard Revision 2.0
Compliant with PCI Bus Power Management Interface Specification Revision 1.2
Compliant with PCI Local Bus Specification Revision 3.0
Support over clocking capability on PCI Express interface
USB Feature
Support 1x USB3.1 Type A and 1x USB3.1 Type C
Compliant with Universal Serial Bus 3.1 Specification Revision 1.0
Compliant with Universal Serial Bus Specification Revision 2.0
Compliant with eXtensible Host Controller Interface specification Revision 1.1
Compliant with USB Attached SCSI Protocol Revision 1.0
Integrated Power supply, two ports share with 5V/5A supply
Support USB3.1 and USB2.0 Link Power Management
Support Control, Bulk, Stream, Interrupt, Isochronous transfer type
Support independent port power control
Support over current detection
Support Remote/Wakeup event
Backward compatible with Legacy USB function and device
Support the Debug port
System Requirements
Windows® Server2003/Vista/7/8/8.1/server2012 R2 x64 (32/64 bit)
One available PCI Express x4 or x16 slot (Recommend PCI Express 2.0)
*NOT supported PCI-Express x1 slot
Package Contents
1 x PCI Express USB 3.1Type C+A Card
1 x Driver CD
1 x User Manual
Hardware Installation
1. Turn Off the power to your computer.
2. Unplug the power cord and remove your computers cover.
3. Remove the slot bracket from an available PCIe X16 slot.
4. To install the card, carefully align the cards bus connector withtheselected PCIe slot on the motherboard. Push the board downfirmly.
5. Replace the slot brackets holding screw to secure the card.
6. Replace the computer cover and reconnect the power cord
Driver Installation
For Windows® Vista/Win7/Win8/Win8.1 (32/64 bit)
1. Please insert the CD driver bound with USB 3.1Type C+A PCIExpress Card into your CD-ROM Drive.
2. At the Windows desktop, click Start, Run.
3. Type D:\USB3.1 Asm1142 \Setup.exe, click OK. (ChangeD: to match your CD-ROM drive letter)
4. Follow the on-screen instructions to complete the installation.
To Verify Driver Installation
Click on the Device Manager tab in System Properties, which youaccess from the Windows Control Panel. You should see a ASMedia XHCI 1.1 Controller under the Universal Serial Bus controllers item.
