Features480x320 hardware resolutionResistive touch controlSupports any revision of Raspberry Pi (directly-pluggable)Supports Raspbian / Ubuntu MATE* / Kali / Retropie, driver provided (Ubuntu MATE on Pi 4B is not available now, until the official image is released)Supports FBCP software driver as well, allows to config software resolution and set up dual-displayIPS technology, high quality and perfect displaying from very wide viewing angleSize perfectly fits the Pi (Raspberry Pi B+/2B/3B/3B+/4B)High quality immersion gold surface platingCombined with the Raspberry Pi, allows
youto: *Take photos by touching (up to 17 camera modes) * Use software keyboard (system interaction without keyboard/mouse)FAQWhy the LCD doesn't work with my Raspbian? *To use the LCD with the Raspberry Pi official image, driver should be installed first. Please refer to the user manual. *However, for the first testing, you may want to use our provided image directly. Why the LCD still doesn't work with the provided image? *Make sure the hardware connection is correct and connects fine. *Make sure the image in TF card is burnt correctly. *The PWR will keep on and the ACT will keep blinking when the Raspberry Pi starts up successfully, in case both of the two LEDs keep on, it is possible that the image was burnt incorrectly OR the TF card was in bad contact. Which power supply should I use? *It is recommended to use a 5V/3A power adapter for the Raspberry Pi other than USB connection, otherwise the Pi may failed to start up because the PC's USB port might have not enough power. Package Contains 3.5 inch RPi LCD (B) *1 Touch pen *1RPi screws pack (2pcs) *1Quick start sheet x1
youto: *Take photos by touching (up to 17 camera modes) * Use software keyboard (system interaction without keyboard/mouse)FAQWhy the LCD doesn't work with my Raspbian? *To use the LCD with the Raspberry Pi official image, driver should be installed first. Please refer to the user manual. *However, for the first testing, you may want to use our provided image directly. Why the LCD still doesn't work with the provided image? *Make sure the hardware connection is correct and connects fine. *Make sure the image in TF card is burnt correctly. *The PWR will keep on and the ACT will keep blinking when the Raspberry Pi starts up successfully, in case both of the two LEDs keep on, it is possible that the image was burnt incorrectly OR the TF card was in bad contact. Which power supply should I use? *It is recommended to use a 5V/3A power adapter for the Raspberry Pi other than USB connection, otherwise the Pi may failed to start up because the PC's USB port might have not enough power. Package Contains 3.5 inch RPi LCD (B) *1 Touch pen *1RPi screws pack (2pcs) *1Quick start sheet x1
