The HighPower Wi-Fi AP/Repeater is ideal for long distance point-to-point/multi-point wireless data transmission, providing a free Wi-Fi service in remote such as factory, community, street or etc. The AP/Repeater can take an existing 2.4GHz wireless signal, repeat and extend it to a longer range where it is far away for the router or access point to reach, and it supports 2.4G transmission speeds of up to 300Mbps.
1.5km Wireless Data Transmission: Specially designed for outdoor uses, ideal for long distance wireless data transmission over 1.5km(only for paired PtP or PtMP transmission), tested in the barrier-free field. Built-in 11dBi directional antennas can significantly improve the transmission and reception performance of wireless signal.
Order two/more sets to achieve point-to-point/point-to-multipoint applications, distance between two sets can be 1.5km, equivalent to bringing your home ethernet port to an remote area.
It supports up to 64 devices and provides 300Mbps high speed with 100M Ethernet port and 2*2 MIMO antenna. Point to Point/Multi-Point connection (1-4) can be used for elevator monitor/surveillance networks. Simple settings can achieve wireless.
Simple settings can achieve wireless optimization, and improve the quality and effectiveness of link transmission. (200 meters wireless data transmission range specifically determined by the environment and the antenna gain and power of the client.)
Multi-Working Modes Accessible
Supports AP/Router/Repeater Mode, which can meet your network requirements in different environment.
- Repeater Mode is for extending wifi coverage of an existing wireless network;
- Router Mode is for creating an instant private wireless network and enable multiple devices to share it;
- AP Mode is for covering a wired network to a wireless network.
200 meters wireless data transmission range specifically determined by the environment and the antenna gain and power of the client.
24V passive PoE adapter supports up to 80 meter (262 feet) deployment, for easier installation and lower cost. And it can be installed in areas where power outlets are not readily available, eliminating the mess of altering existing network infrastructure.
6 status LED indicators help you see the power/ internet status of device. Since the green lights might be not so obvious in the open air, you can try to cover the device with your hand to check.
1.5km wireless data transmission range for point to point/multi-point use(the result is from testing two products use together---one as sender and one as receiver), suitable for surveillance networks.
Panel (L * W * T): length 19.5cm/7.68in, width 12cm/4.72in, thickness 3cm/1.18in; Router: diameter 4.5cm/1.77in, height 17cm/6.69in. Note: Data by manual measurement for reference ONLY.
DC 24V/0.5A passive POE integrates power interface and Ethernet port. The power cable does not connect to 570hp2 directly, thus it can avoid safety issues caused by wind and rain. 1 meter R-J45 network cable is included. You can replace it with longer one, under 80 meters is recommended.
- IP65-rated weatherproof housing
- Withstanding broad ranges of humidity and temperature(-30°C~70°C) (-22°F~158°F)
- Build in lightning arrester (15KV ESD), 4KV lightning protection
IP65-rated waterproof housing that ensures continued operation on harsh outdoor environments or in climates of extreme cold, heat or continuous moisture. Lightning protection and weatheproof design ensure stable connection in harsh outdoor conditions.
11DBi Directional Antenna Panel
With two built-in directional antennas, it extends WiFi in a directional and focused manner on the front (single set can reach maximum 300 meter coverage in barrier-free environment), purposefully and efficiently making the most of your home network even outdoors.
Installation Height: Keep the height of the flat antenna 2-3 meters above the ground without obstruction, and 1-2 meters horizontal drop from the network terminal (mobile phone, surveillance camera).
Installation Direction: The signal facing the front of the panel antenna is much stronger, please pay attention to whether the front and back of the antenna panel are facing correctly when installing.
Installation Steps: Support flexible deployment on the wall or on the round pole. For detailed steps, please refer to our step-by-step diagrams in this page or installation instructions in the package.
* The real performance of the product may vary in accordance with different environmental conditions.
* If your device is damaged or defective, please contact our customer service for more details.
* All pictures shown on the package are for illustration purpose only.
1x Outdoor WiFi Extender, 1x Antenna Panel, 1x Main body holder
1x POE converter, 1x RJ-45 network cable(1 meter), 1x Power adapter (US-Spec)
1x Screws Bracket fitting kit, 2x Cable ties, 1x Installation instruction