OCP NIC 3.0 Small Form Factor

PCI-Express host interface specification v2.0 with 5GT/s BUS width

PCI-Express lanes: x8

Complies with Dual port 10GbE SFP port

Complies with IEEE802.3ae specification

Layer 2 functions: IEEE 802.3x Flow Control - IEEE 802.1q VLAN

Supports Receive-side scaling (RSS)

Supports IPv 4, IPv 6 protocols

Supports Jumbo Frames up to 15.5K

Supports Checksum offloading

Statistics for management and RMON

Support for virtual machines device queues

Interrupt throttling control to limit maximum interrupt rate and improve CPU usage

Chipset: Intel JL82599ES

Drivers support for FreeBSD, Linux , VMWare ESXi, Win7/ Win-server2012/ Win-server2008/ Win8/Win8.1/Win-server2016/win10

Package content

1 x OCP3.0 X520DA2 SFP+ Network card

1 x CD Driver

1 x Low profile bracket

Accessories

System Requirements

FreeBSD, Linux , VMWare ESXi, Win7/ Win-server2012/ Win-server2008/ Win8/Win8.1/Win-server2016/win10

An available OCP3.0 SFF slot

Cabling Requirements:

Intel 10Gigabit adapters

SFP+ Module Laser wavelength:850 nanometer (not visible)

LC Cable type:

Multi-mode fiber with 50 micron core diameter, maximum length is 550 meters

Multi-mode fiber with 62.5 micron core diameter, maximum length is 275 meters

Connector type: LC

SFP+ Module laser wavelength:1310 nanometer(not visible)

LC Cable type:

Multi-mode fiber with 9 micron core diameter, maximum length is 3K meters

10 Gigabit Ethernet over SFP+ Direct Attached cable(Twinaxial)

Length 10 meters max.


Hardware installation

1. Turn off the computer and unplug the power cord.

2. Remove the adapter slot cover from the OCP3.0 slot that matches your adapter.

3. Push the OCP3.0 adapter card inward along the track of the slot until the bracket is level with the chassis and lock the screws to secure it.

4. Power on the computer

Install Drivers and software

Windows Operating Systems

You must have administrative rights to the operating system to install the drivers.

1.insert the CD driver bound with Intel network driver into your CD-ROM drive(also you can download the latest drivers from support website):

2.if the Found New Hardware Wizard screen is displayed, click Cancel

3.start the autorun located in the software package, the autorun may automatically start after you have extracted files.

4.Click install Drivers and Software

5.Follow the instructions in the install wizard to finish it

Installing Linux Drivers from Source Code

1.Download and expand the base driver tar file.

2.Compile the driver module

3.Install the module using the modprobe command

4.Assign an IP address using the ifconfig command


Support

More information and settings, please refer to the Intel Adapter User Guides or you can contact us.